Refresh the page to show your instance and installation status.
You can follow the compilation by looking at the
# tail opt/slapos/log/slapos-node-software.log -f
Since the Registry is listening on port 19201 (see
and user permissions in Linux systems prevent accessing ports above 1024,
traffic must be forwarded (also describe in installing SlapOS node COMP-0).
This can be done using a Firewall with NAT traversal or using Socat.
Socat is a relay for
bidirectional data transfer between two independent data channels. Data
channels can be files, pipes, devices (terminal or modem, etc.), or
sockets (Unix, IP4, IP6 - raw, UDP, TCP), etc. For more information, please refer to
the Free Software Directory).
To install socat in case required, use
$ sudo su
# sudo apt-get install socat
Then start by finding the IP adress to bind to:
# netstat -natp | grep 9201
tcp 0 0 10.0.27.44:9201 0.0.0.0:* LISTEN 26027/python2.7
tcp 0 0 10.0.27.44:40706 10.0.27.44:9201 TIME_WAIT -
tcp 0 0 10.0.27.44:40699 10.0.27.44:9201 TIME_WAIT -
tcp 0 0 10.0.27.44.9201 10.0.27.44.:40655 TIME_WAIT -
tcp 0 0 :::9201 :::* LISTEN 26027/python2.7
# ifconifg eth0 | grep inet\
inet addr:220.127.116.11 Bcast:18.104.22.168 Mask:255.255.255.255
Then call Socat:
# socat TCP4-LISTEN:9201,fork,bind=22.214.171.124 TCP4:10.0.27.44:9201 &  13443
Note, that your Registry master-url in the example is 126.96.36.199:9201.
SAVE THIS URL. You will need to provide it whenever you want to connect
a new node to the network.